The rock button bits is a simple, lightweight and economical road header for a wide range of applications in road construction, road construction, road construction and road heading. Infrastructure construction, mining and other industries, is an important machine in the stone barren material mining. On the one hand, this equipment work reliability, safety put forward a high demand; on the other hand, also to the operation and maintenance of the equipment brings The correct handling of rock button bits not only ensures safety in production, but also reduces the risk of malfunctions. Correct operation of the rock button bits not only ensures production safety, but also reduces the risk of malfunctions. So the following rock button bits manufacturer - kaiqiu drilling tools to tell you about this Knowledge on the one hand.

　　The use of the brazier is by the quality requirements, the use of substandard brazier is prohibited. Duct access rock button bits, should be deflated to blow out the dirt in the off. The air duct and water pipe must be tightened to prevent the dirt from falling off and hurting people.

　　Insert the end of the brazier into the button bits, turn the brazier clockwise by force, if it doesn't turn, it means the machine is not working. There is a jam inside, which should be dealt with promptly. Tighten the connection bolts, open the air to check the operation of the thruster, operate normally before starting work.

　　Guide rock button bits should be set up to support and check the operation of the thruster. rock button bits and up rock button bits must have their air legs checked. The degree of flexibility and other conditions. Hydraulic rock button bits should require a good sealing of the hydraulic system to prevent contamination of the hydraulic fluid. To ensure a constant pressure in hydraulic oil.

　　If the rock button bits is stuck, reduce the shaft thrust, then it will be normal gradually. If this does not work, stop the drill immediately. If this doesn't work, please stop the drill immediately. First use a wrench to turn the brazing rod slowly, then turn the brazing rod slowly with medium air pressure. Pay attention to the oil storage capacity and oil delivery condition, and adjust the amount of oil injection. When working without oil, it is easy to make the parts wear out prematurely. When there is too much oil, it will cause pollution of the working surface.